Cars are one of the most common means of transportation in our daily lives, which shows the importance of cars. It is also because of this that the automobile market is developing very well. Many friends also like cars very much and have a certain understanding of cars. But compared to most of them, it is a minority. Today, the editor will introduce you to the correct method of lifting the clutch.
The correct way to lift the clutch: the correct way to lift the clutch
1. The correct method of stepping on the clutch should be to use the left heel as the fulcrum and use the forefoot to step on the clutch pedal;
2. When the car starts: When the car starts, first depress the clutch quickly, and then quickly release it to the semi-linked state. At the same time, slightly increase the accelerator to increase the speed of the car, and then slowly lift the clutch. Pause for a while;
3. When the car is shifting gears-downshift: first reduce the speed of the car until the speed is reduced to the need to downshift, quickly step on the clutch, and then use the principle of "one fast, two slow, and three linkage" to control the clutch;
4. When the car is shifting gears-upshift: increase the throttle to increase the speed of the car, then quickly step on the clutch, lift the clutch slowly, and slightly increase the throttle during the process of lightly lifting the clutch;
5. When the car is parked: When the car speed needs to be below 15 KM/H, step on the clutch, and then use the brake to stop the car. After the car is completely stopped, slowly release the clutch;
6. Other precautions: 1. Do not put your feet on the clutch for a long time; 2. Do not step on the clutch as soon as you step on the brake, so that the clutch is in a semi-linked state for a long time; 3. Step on the clutch before stepping on the car when going downhill.
The correct way to lift the clutch: the correct use of clutch
The main points of clutch operation: fast lifting and stopping, slow lifting and stable, which means that fast lifting is the free travel from the beginning to the semi-linkage position, and when the semi-linkage is reached, it is necessary to slow down the second half and release steadily.
The semi-linked position is the position where the clutch friction plate and the pressure plate must be in contact but not fully in contact. When experiencing, you can add the door appropriately and slowly lift the clutch on a small uphill road. When the vehicle feels that it is going forward, keep the clutch Position, release the handbrake, at this time the vehicle can stop on the ramp without stepping on the brake, lift the clutch car forward a little bit, and press the clutch car backward, this point is the semi-linked position. Remember the position of your feet at this time.
In addition, the engine often stalls at the start. If you are a novice, it may be caused by not following the oil in time. When you reach the semi-linked position, you must follow the oil in time before the car has the power to move forward.
The correct way to lift the clutch: Clutch
The clutch is located in the flywheel housing between the engine and the gearbox. The clutch assembly is fixed on the rear plane of the flywheel with screws. The output shaft of the clutch is the input shaft of the gearbox. When the car is running, the driver can step on or release the clutch pedal as needed to temporarily separate and gradually engage the engine and the gearbox to cut off or transmit the power input from the engine to the transmission. Clutch is a common component in mechanical transmission, which can separate or engage the transmission system at any time. The basic requirements are: smooth joint, rapid and thorough separation; convenient adjustment and repair; small outline size; small quality; good wear resistance and sufficient heat dissipation capacity; convenient operation and labor-saving, commonly used are divided into jaw type and Two types of friction.
